» Topics » DIY ideas »Lamp per hour

Lamp per hour


Hello everyone let's get started
You will need:
- soldering iron (soldering accessories)
- knife
- the remains of the LED strip
- transformer 12v 30 w
- some wires 2 / 0.75
- trim profile (taken from a friend ceiling)
- silent film of the ceiling (all from the same friend)
- a small segment of the tape (like a harpoon - from the words of the same friend)
- chopped suspension 2 pieces
- 4 small screws
- cosmofen glue (by the way good glue)

Well, a little time, in general, I soldered the St. ribbon and glued it to the profile, twisted pieces of suspensions for fastening from the back of the profile, then glued a “gorun” around the perimeter of the previously cut off piece of the ceiling. Then I connected it to the transformer (the cheapest Chinese one), and then, by choice, I connected the transformer from the transformer to the network together with the spots and hid it behind a screen, it’s possible to the plug, as you like.

soldered
pasted and glued a piece of the ceiling



then he warmed up a little the ceiling already worn on the profile, cut off the excess and laid it out on the balcony for several minutes to smooth the ceiling. Then he hung around, until approximately later he hid everything


and result
Question \ topic is automatically published in the social. site network - stay tuned for answers there:

Suitable for topic

Related topics

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose

We advise you to read:

Hand it for the smartphone ...