Step 1: Take a construction foam 2 cm wide. Then it measures 20 cm and 22 cm on each side. Cut a small piece of polystyrene with a clerical knife.
He duplicates this piece several times.
He carved five such details.
Step 2: The master collects a similar structure from the details of the box, its width is twenty cm. Twenty four cm high and twenty two cm deep.
Step 3: The author takes reinforced tape and fastens the walls.
Step 4: The master cuts strips of foam 4 cm wide., And glues inside the incubator.
Step 5: The creator takes a grid (such as shown in the photo) and cuts out the volume of the incubator.
It has inside.
Step 6: He takes the plug, cable, adjustable switch and lamp with a bulb. It brings it all together and gets the ability to adjust the lamp light.
Step 7: In the roof of the incubator, it cuts openings for the cartridge and regulator. Puts them in their place.
Step 8: From a piece of transparent plastic, the creator is about to make the last wall.
Step 9: The master makes ventilation with a nail, he warms it up and makes holes in the corner of the incubator.
Step 10: Curving the paper clips, the creator made the clips.
11 Step: He pours water into the container and puts it under the net.
Using a sensor, it will monitor temperature and humidity.
Due to the lack of moisture, I decided to add a container of water and cubes from the sponge.
Step 12: The master takes the eggs and inspects them for damage, then he marks them with a marker.
After these manipulations, the author will lay the net for less and lay eggs on it.
All the incubator is ready.
Video: