With this jack you can lift one side autowithout straining in just a couple of seconds.
The author took the old rear brake pad from a truck.
Cut off an unnecessary piece from her. So that half the pads can be aligned.
And with the help of a hammer he leveled half of the block.
The result was such a blank similar to ski.
Also took a piece of thick-walled pipe.
And welded it to the block.
It also took a piece of curved metal, took half from the old starter, but it can be replaced with a piece of thick-walled corner.
He honed the edge of the pipe so that half of the starter rests tightly on it.
Further, the author welded the pipe to a half from the starter.
Then he strengthened the platform by welding a piece in the form of a triangle of thick metal to it.
So the author’s tool is ready.
Before painting, I decided to test it.
And as it turned out, it was not in vain in the snow that the instrument simply slipped. And I decided to fix it.
Having removed the pad from the pad, he welded a piece of a stud that will serve as a spike, and also on a flat surface he made anti-slip points.
And again the test.
According to him, after completion, the tool copes with its task perfectly, even in the snow.
The length of the pipe should be approximately 5 cm longer.
Than the height of the place for which you will raise the car.
Now he cleaned the finished jack well, degreased it and painted it.
Thank you all and see you soon.
Video: