DIY do-it-yourself lamp

Good day to all. This article will discuss how one master assembled a locksmith lamp from an old corrugation for a shower. As the author collected it, you can find out by reading the article to the end.

And so, the master took the corrugation and removed the old hose from it.

Then he cut off a piece of 80 cm long from the corrugation.

Next we needed a wire with a plug and a piece of thick aluminum wire.

Securing the aluminum wire with the plug wire.

The author passed both wires into the corrugation.

Then he took an old CD, and with the help of a red-hot nail, he made a couple of holes in these places.

Then he fixed the disk to the corrugation.

Then I cleaned both edges of the electric wire (with a plug). I connected such a cartridge to them and mounted it on the disk.

Then he, tightly squeezing the corrugation, cut off the excess aluminum wire and fixed the corrugation in this position with the electrical tape wires.

The lamp is ready.

I installed the assembled lamp at the drilling machine. I installed a light bulb in the cartridge and connected it to a power source. And as we can see, the locksmith is working.

According to the author according to this principle, it is possible to make a stand for a table lamp, which will rotate in any direction, or a tripod for a photo or video camera. Well, that’s all. Thank you all and see you soon.

Video: