First of all, the author took the angle grinder, which he will turn, using the box into a circular saw, the box made of laminated plywood 18 mm thick. Well, about this a little later.
First he made a bracket from a 4 mm metal strip. Made a hole on one edge of the strip. Cut off a piece of the right size.
And bent it as shown in the photo. According to the author, the configuration of the gearboxes on the angle grinder is different and therefore the bending angle should be made for each model The angle grinder is individually customized under the gearbox.
On that part of the bracket that will be in contact with the gearbox, I glued a piece of rubber.
The hole on the bracket should be along the outer edge of the thread on the angle grinder.
Four small holes for guides were also made, and in the center there was one larger one for attaching the bracket to the box.
He fixes it to a angle grinder with a bolt and washer.
As previously written, the box was assembled from laminated plywood.
Gearbox cutout.
Bracket mounting bolt.
Guides made from old broken drills.
From above, he installed a plate of 2 mm stainless steel, having previously removed several layers of plywood.
The bracket mount is located under the sheet. I did it like that, I cut off the cap of the bolt a bit and turned the edges. Then in the box made a hole, sweat, and put the bolt on epoxy.
Gathers a saw.
On the side of the box, the author made a hole for the disk lock button.
Disks are changed without removing the angle grinder.
To adjust the speed will use a homemade dimmer.
Assembled from such a board.
For collecting chips made such a pallet.
Vacuum cleaner hole.
The author uses a car, but advises to take, some more powerful.
He made an emphasis for workpieces, too, from 18 mm plywood. The stop is fixed with a bolt, which, when tightened, squeezes a piece of rubber corresponding to the diameter of the bolt.
For convenience, it uses an extension cord with a built-in switch. Test board 20 mm.
Board 30mm.
Also, such a movable table was made here. For trimming workpieces at right angles.
The saw blade is hidden in the shank, thus ensuring safety.
All parts can be stored inside the box.
Thank you all very much and see you soon.
Roller: