To make a table you will need:
From materials:
1. piece of glass
2. pvc plastic (white)
3. 15 white LEDs
4. wires
5. 3.7V charging module
From the tools: Soldering iron, superglue, knife, double-sided tape, sandpaper
First you need to do electronic part of the table. All 15 LEDs need to be connected in parallel. After soldering, you need to solder the wires to the LEDs and "dress" them in heat shrink.
The ends of the wires must be soldered to the charging module (observing the polarity!). After connecting - check!
Now we turn to the manufacture of the table itself. You will need such a piece of glass with dimensions of 30 by 26 centimeters.
After removing the protective film, sand the surface with sandpaper.
It should look like glass after processing.
Now all glass needs to be smeared with superglue.
From a piece of PVC plastic it is necessary to cut a piece with the same dimensions as that of glass. Sandpaper and then glue.
Now, from a piece of black plastic (if there is no black, you can paint over white plastic with a black marker), you will need to cut two strips of 26 by 5 centimeters.
Superglue should be smeared on one edge of the strip, and then glue it to the glass.
Now you need to cut a strip of pvc with the same height as the thickness of the glass. After cutting, stick it to the other edge of the black strip.
After the glue dries, all the electronics need to be “stuck” on double-sided tape.
Now the walls are made of pieces of plastic and glued to superglue.
Having thoroughly missed all the edges, the top cover is glued.
Well that's all, it remains only to connect the table, and you can start translating pictures!
Thanks for attention! Original video of the author: