In this article, we will look at how to make a two-sided mirror of infinity. To make such a mirror, you need the following
Tools and materials:
- Electric jigsaw;
-Drill;
-Drill;
-Gon;
- Joiner's glue;
-Rasp;
-Soldering iron;
-Rail;
-Board;
-LED Strip Light;
-Tinting film;
-Connector;
-12V power supply;
- Orgsteklo;
-Bolts;
-Nuts;
-Glue gun;
-Pencil;
Step One: Frame Making
First, the master cuts off nine pieces of reiki. The angle washed down is 20 degrees. Then glues the parts together. Cut the last short piece and paste it into the frame. According to the author, such irregular segments were obtained due to incorrect calculations, but they do not affect the final product.
Step Two: LED Strip
On the opposite side, from a short length, the side of the frame measures the middle. From the middle glues the LED strip around the inner perimeter of the frame. The tape needs to be glued as close to the center as possible. The master makes a small gap between the edges of the tape.
Drills a hole in the frame between the edges of the tape. Draws a wire into the hole. Solder it to the contact of the tape. Checks the operation of the LED strip.
Step Three: Plexiglass
Cuts two pieces of plexiglass to form a frame.
Step Four: Toning
Peel off a protective film from plexiglass. Cuts off a piece of tinted mirror film. The film is glued to the part of the plexiglass that will be facing inside the frame. To install the film, the master makes a soap solution and puts it on plexiglass. Attaches a film and expels air bubbles from under it. Then cuts off the edge of the film. Repeats the same operation with the second plexiglass.
Step Five: Mounting Holes
The mirror will be assembled on four bolts. The master drills mounting holes in the frame and plexiglas. When drilling, it is necessary to observe alignment.
Step Six: Build
Collects a mirror.
Seventh step: stand
To install the mirror in an upright position, the Master makes a stand.
Installs the mirror on the stand and checks the operation of the LEDs.
Everything works, it remains to remove the protective film from the outside of the Plexiglas.
The two-sided mirror of infinity is ready.
The whole process of manufacturing such a mirror can be seen in the video.
In my opinion, an axis and a sliding contact could be installed on the frame. In this case, it would spin and it would look much more spectacular.