Are you tired of chopping vegetables by hand? Then you need to see how the Master made the electric drive for his shredder. Of course this product is more likely model and is not intended for heavy loads, but following this instruction you can make a complete product. For the manufacture of an electric drive, the master used the following
Tools and materials:
-Engine;
-Plywood;
-Glue gun;
-Compass;
-Rule;
-Pencils;
-Drill;
-Bolt;
-Glue;
-Syringe;
-Knife;
-Battery;
-Battery connector;
- Shredder;
-Screwdriver;
-Screws;
-Plastic pipe;
Step one: engine and housing
For his homemade the master uses a constant engine of 30 rpm. From plywood cuts a square. In the center makes a hole for the engine. Sets the engine, fixes with hot melt adhesive.
Glues the base and side walls.
Step two: crank
On plywood draws a circle and a rectangle.
Cuts parts.
These two parts will be connected using a bolt.
Glues the wheel to the motor shaft.
Cut off the front and back of the syringe. The resulting cylinder cuts into two equal halves. Glues cylinders to a rectangular part.
Glues another part.
Checks how pencils become in cylinders.
Collects a crank.
It connects the battery and checks the operation of the mechanism.
Step Three: Shredder
Cuts the top cover.
Sticks it.
Glues the guides.
From the shredder breaks off the handle.
Screws the shredder to the lever.
Step Four: Tray
The master made the tray out of a piece of plastic pipe mounted on plywood.
Sets the tray.
Checks the operation of the shredder.
The whole process of making an electric shredder can be seen in the video.
[media = https: //youtu.be/aWg2D4jpEYo]