Today I will tell you how the Master made a bluetooth speaker.
Materials we need:
1.Glue
2.Audio amplifier with built-in bluetooth
3.Dynamics
4.Switch
5.LED resistor
Instruments:
1.Drill
2. Clips
3.Saw
1.Glue
2.Audio amplifier with built-in bluetooth
3.Dynamics
4.Switch
5.LED resistor
Instruments:
1.Drill
2. Clips
3.Saw
Step 1: Layout and Create the Wireframe
The author marked all sizes and assembled the column frame.
Step 2: Front
For the front side, the author uses a 1/4-inch white oak. He highlighted the area for two speakers, and drilled holes on a drilling machine.
To round the edges a little, the author uses a milling cutter.
Step 3: Finalize
The author marked the places for the switch and LED and drilled holes.
Step 4: Grinding
Further, the author polished all parts of the column.
Step 5: Cover
Further, the author made mounting the rear cover on the screws for further convenience in installing electronics.
All electronics that the author uses for the column.
Step 7: Adding Components
Then the author painted the front panel and set the switch.
Step 8: Install All Electronics
The author installed all the electronics with a button with an LED, glued the power connector to the case.
Step 9: close the column
The author, setting the amplifier on hot glue and securing the wires to the speaker case, closed the column cover to the building.
Step 10: Feet
Further, the author decided to make small legs for the column from pieces of a lagging tree.