In this article, the author of YouTube channel "Thaitrick" will tell you what useful homemade and fixtures obtained from simple plastic bottles.
This is a continuation of the previous tips.
Materials and tools.
- soldering iron
- glue gun
- Silicone
- Scissors, stationery knife
- screwdriver
- Scotch.
So let's go!
Tip 1: Cut the bottom of a large eggplant, and then cut such a shape out of it. Then melt the cut points with a lighter. So varnishing your hair is much easier and safer. True, you need an assistant. Such an impromptu mask can be useful when working with a power tool.
Tip 2: And here's how to get out if you don't have a tripod.
We make a hole in the cork with a soldering iron or a sharp knife, we screw a bolt there from the inside.
We screw the stopper on the neck of the bottle.
We wrap the camera onto the protruding pin from the bolt. The tripod is ready!
Tip 3: No candlestick? - no problem! Do you have two bottles of 1 and 05 liters? Then cut off the necks from them and glue them together with any glue, or with a glue gun. All! Insert a candle. Now the drops of wax will remain in the candlestick.
Tip 4: But how can you get out in hot, dry weather, especially if you need to leave for a short while and water homework no one plants. Such a simple device will add water little by little, as the soil dries.
Tip 5: Cut the bottle into three sectors. The middle part is not needed. Insert the neck of the bottle into its bottom. So your sponge will not stagnate, mold and rot.
Tip 6: And so a little ring, or small values will not be lost, and won’t drown!
Tip 7: If you cut off the top of the bottle and make a deep slot, almost to the bottom, you can dry your cups like that. Just match the size of the cups. At the same time, it will be convenient to transfer several mugs at once.
Tip 8: In front of you is a regular protective cap. If there is a cat at home, your soup will most likely remain intact, the flies will certainly not touch him. Yes, the dish will not cool so quickly!
Tip 9: Have you ever made a protective suit for an extension cord? Do you think this is superfluous? What about dirty work in the garden or at home? This element doesn’t hurt!
Cut the neck of the bottle, make a long slot, almost to the bottom, put an extension cord in it. Now bring the cords out through the slot, and cover the open part of the block with a cut-off neck. Remember to cut it to the side. Now dirt and dust will not get into the extension cord.
Tip 10: It so happens that there is nowhere to stick toilet paper, and not hygienic. Take a large eggplant, cut off its upper part. With a soldering iron, make holes on the sides of such a diameter that a round wand, or a needle, can creep into it. Put toilet paper on it and thread it through the holes, one at a time. The holder is ready!
Tip 11: And so, from the cut bottom of the bottle you can make a wonderful palette.
Tip 12: Cut the two middle parts of the bottle of the same length.
Add them like this and cut off the excess.
Fold each strip in half - we get such volumetric squares. And from two volumetric squares, if you pass them one into the other - a cube. Now you can beautifully arrange a gift!
An unexpected turn, right ?!
Tip 13: Cut the neck of the bottle, glue it with reinforced tape. We drill holes for bolts in a wooden board and in the bottle itself. We fasten the board and bottles with bolts and nuts. We hang the board at an angle to a wall or a fence. Wonderful inbox!
Tip 14: You did the dirty work, and there’s no one to drain on your hands. Make yourself an eggplant washbasin! Underneath with a soldering iron or a nail, melt a small hole. Plug it firmly with your finger and draw water into the container to the very top. Screw on the cover, release your finger. Do not be afraid, water will not spill out! Air pressure will not let her do this. But if you open the lid, then it’s a completely different matter. Wash up soon! Water must be saved.
Thanks to the author for an interesting selection of ideas and tips!
Good luck to everyone and good mood!