Hello everyone, today I will tell you how the Master brought a modern touch to his house.
Instruments:
1. Jigsaw
2. Clips
3. Roulette
4. Saw
1. The author used a miter saw to cut the bars to the desired length.
The author then used a planer to remove several layers to reduce sanding time.
2. To facilitate the assembly process later, the author first made all the matching sections. The author used a table saw to cut the poses at both ends of the three parts. Although a table saw would be the fastest way to make these cuts, you can achieve the same cut using a reciprocating saw, circular saw or handsaw. After you have made your cuts, you can check the parts by inserting them into place.
3. To assemble the armrests of the chair, you must start by stacking the bars as shown. Apply wood glue to each joint and distribute the glue evenly to ensure a uniform coat. Using glue for wood, you prevent future creak.
4. Place the armrests next to each other so that you can attach the back and bottom of the chair. The author used several pieces of wood to make sure that the seat would be the same height front and rear.
6. To hide the screws, the author used a wall plug to close the holes. The author put some glue on the dowels and used a rubber mallet to hammer them. Then the author wiped all the excess glue around the dowel and used a saw to cut off the deprivation of part of the dowel.
]
6. The author began to assemble the seat by first adding two outer bars as shown. Then glue the support element under the bottom of the chair and screw it into place. Then use pieces of wood to maintain a constant distance between the remaining parts of the seat. The author secured the bars using two screws on the board.
7. The author polished the chair, then applied a wood conditioner to help remove any stains. After the tree dried, the author varnished everything.