The master made this coffee table with a set of gentlemen for a gift to his retiring leader. To make such a gift, the master needed the following
Tools and materials:
-Bandsaw machine;
- Planing machine;
-Jointer;
-Grinder;
-Hair dryer;
Milling cutter;
-Gon;
-A circular saw;
-Drill;
-Lathe;
-Wood;
-Special tree;
- Paint tape;
-Aerosol paint;
Epoxy resin;
- Joiner's glue;
-Dye;
-Polish;
-Super glue;
-Material for interior decoration;
-Legs;
-Soda;
Step One: Cutting Wood
The first step is the master processes the boards, cuts, planes.
Step Two: Cut
Now you need to prepare a saw cut. Cuts the saw cut into two parts along. Folds together and on one side under the ruler cuts off part of the wood.
Step Three: Drawer Assembly
Then the master collects the box.
After assembly, cuts it into two parts.
Step Four: Resin Pouring
Over the lid makes a side. The lid itself is painted black.
Glues to the saw cover.
Knead epoxy. Adds dye.
Pouring resin. Heats it with a hairdryer to remove air bubbles. Leaves to dry for twelve hours, then fills the next layer with less dye. The master pours the third layer, after drying the first, without dye.
Simultaneously with the first filling, the master makes a pen. A wooden block is laid in a prepared box and a part of the resin with dye is poured.
Step Five: Drawer Handling
After the resin has dried, the master cuts the edge of the wooden base to the same level as the flooded surface.
The master himself processes the box with a soda solution (2 tablespoons of soda per 250 ml of warm water, and then grinds it.
Covers the product with beeswax.
polishes the flooded surface with an emery paper grinder up to 600 green.
Step Six: Pen
He takes out the handle blank from the mold and processes it on a lathe. Then secures the mount from the purchased handle to the box lid. Glues an epoxy handle to the mounts.
Now it remains to fix the legs, finishing material, install hinges and locks and do not forget about glasses and a bottle of cognac.
