» Modeling » Aviation »MiG –C Sharp Air Model - Sharp

MiG – S “Sharp” Model - Sharp


The video of my old friend inspired me to create this model.



I watched his video carefully and took several photos from it.

I have already built the "Vector" and "Jeb" models seduced by him modelsseen on his video. I already talked about them.


Once I already built a MiG - 19 aircraft. But it was with an impeller, and this model will be with a motor.

Cut a small model from a sheet of ceiling.




"Chief Engineer" gave the go-ahead.

Having checked it for “volatility”, I decided to make a full-scale model.
The material served, as usual. A simple sheet substrate for a laminate, 5 mm thick.

Again, I took the drawings of the MiG - 19 aircraft as a basis.
MiG – S “Sharp” Model - Sharp

I won’t explain anything in detail. Everything is clear from the photos.
He began, as always, with the most difficult. with wings.





For comparison, I put a small model next to the wings.

With the fuselage, too, there were no difficulties.






It remains to glue the top panel of the fuselage, glue the cockpit, put the pilot in and that's it.

The cabin, as always, was cut out with scissors from a plastic bottle from under mineral water. I cut the pilot out of cardboard and painted with felt-tip pens. The section with the cabin was made removable so that you could install the battery, regulator and receiver in the fuselage.
Put servos, glue hogs, connect traction to controlled surfaces is a matter of time and hand agility.
Put the motor.



I want to draw your attention to the design of the stabilizer and elevator.

Everything is clear from the video.



For the cabin, I took a clear plastic bottle and cut a piece from the front. The result is "Lantern". Pilot cut out of cardboard and painted with felt-tip pens. The cab itself was glued to a panel that can be removed to access electronics and battery replacement. The panel is fixed in place with transparent tape.

He covered the model with colored tape.






A new MiG-S “Sharp” model appeared - Sharp.

"Chief Engineer" tested.

This is during the summer "flying".



This is how the model looks in winter.







A few words about the model.
Length - 1350 mm.
Span - 950 mm.
Flight weight - 450 g.
Motor - 2212 1400Kv
Screw - 8 X 6.
The regulator is 40 A.
Servos - NHT900
Battery - 2200 3S

That's all for now.
9.3
7
7.3

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose

We advise you to read:

Hand it for the smartphone ...