» Topics » Advice »Metal Etching at Home

Metal Etching at Home


Hello! I will show a fairly common etching method, it is very simple. Let's start!

Materials:
- the power supply is 12v 1a (I have 19v 2.4a) it doesn’t really matter, these characteristics depend only on the etching time.
- a wire with a socket for the power supply, at the other end a crocodile (plus) and nails (minus).
- metal
- salt
- water
- cotton wool
- adhesive tape
- scalpel or soldering iron

Stage 1
First, prepare the metal surface for etching. We take solvent or gasoline and wipe the surface.


Stage 2
Then we take tape and glue it on the metal surface.


Stage 3
We put any inscription on the tape, I wrote BMW.


Stage 4
Using a soldering iron or scalpel, we cut out the inscription or drawing.


Stage 5
We start etching. Dissolve the salt in water until the salt ceases to dissolve. Plus we attach to the metal, and minus the nail on which the cotton wool is wound. We dip cotton wool in saline solution and on a previously prepared metal section and poison for some time. Then after 2-5 minutes we get a certain internal pattern.



That's what happened! Everything is as simple as possible, such an engraving can be applied to any metal.

Suitable for topic

Related topics

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose
5 comments
The more powerful the power supply, the faster the metal will be etched.
But you wrote that the characteristics of the power supply depend on the etching time! Although it is necessary - the etching time depends on the characteristics of the PSU!
power supply 12v 1a (I have 19v 2.4a) it doesn’t really matter, these characteristics depend only on the etching time
smile
Not really. It depends on the solution, it is desirable to add citric acid or concentrated vinegar.
And nails as a cathode suck. Only a plate of the same material.
etching .. haha ​​..
PS people, be careful with this technology - chlorine and detonating gas are released. Only work under the hood!
Author
The more powerful the power supply, the faster the metal will be etched.
power supply 12v 1a (I have 19v 2.4a) it doesn’t really matter, these specifications depend on time only pickling
???

We advise you to read:

Hand it for the smartphone ...