Good day to all. In this article I want to tell you about another, in my opinion, useful homemade. Which, the author of the channel "Mr SunY" fashioned.
All that the author needed for this homemade product.
Materials:
The strip is metal.
Not a big bolt with a wing nut.
Metal corner.
A couple of pieces from a metal strip. The width of this strip is less than the previous one by about half.
Hairpin
To her a couple of ordinary nuts.
And a couple of nuts, wing.
Instruments:
Marker
Drill
Drill
Angle grinder
Cutting wheel
Hammer
Pliers
And a welding machine.
And so let's get started.
To begin with, the author measures two pieces of 140 mm from the strip.
Then cuts off these blanks.
After in each of them will make a through hole for the bolt.
Next, connect them with a bolt and nut.
Like this.
Then it will expose the parts at an angle of 90 degrees.
And remove the excess.
Something like this.
Then in this position it will weld this workpiece to the corner.
After it marks 90 mm from each edge of the corner.
And remove the excess.
So it happened.
Further, the smaller plate clamps in a vice and bends with a hammer to the desired shape.
Then it welds these hooks to the corners.
And nuts will be welded to the hooks, As shown in the photo.
Next, he cuts off two workpieces of suitable length from the stud and welds one wing nut on one edge of each of them.
Then install these studs in their places.
And everything is ready, such a homemade product.
Test: Profile pipe.
Water pipe.
Wooden blanks given device also holds well. With this device, the workpieces can be held at different angles.
And that’s all for me. Thank you all and see you soon!