In this article, the author of YouTube channel "PEREC DIY" will tell you how he made the simplest to connect a console for a wood stove. It will allow heating, or maintaining a comfortable room temperature in the absence of firewood, as it will allow the use of waste oil in the form of fuel.
Materials
- Sheet steel
- Trim channel
- Steel pipe scrap
- Used oil.
Instruments, used by the author.
- Grinder, cutting disc
- Welding machine
- Vise, chisel, hammer, file
- Roulette, magnetic corner.
Manufacturing process.
The author already had a potbelly stove, but a large amount of used oil appeared.
These simple materials will be needed for the manufacture of consoles, which will work on oil.
In sheet steel, he makes a hole for the pipe using a hammer and chisel.
In the pipe, along its entire perimeter, the author drilled several holes. Now you need to connect the hole in the sheet steel and the pipe as tightly as possible. Deficiencies can be easily removed with a file.
Then, on a steel sheet, the author makes cuts at the bend points. This will be a fuel tank.
Magnetizes the square to the pipe, connects it to the hole in the sheet, and welds the parts.
Now bends the oil tank.
Boils seams thoroughly.
The first part of the console is ready.
In the upper part of the container, the author made a small filling hole with a lid.
Then, from two pieces of the channel, the master welded such a pipe.
I connected it with the first part, I blown the stoves to the size.
Welded billets among themselves.
I drowned out the second part of the pipe, and everything, the prefix is ready!
He put the device to the blower, and filled with oil.
Then he set fire to the fuel in the lower tank.
As it flared up, it opened the blower, and the prefix worked.
Thanks to the author for a simple but useful prefix for the stove - potbelly stoves!
All good mood, good luck, and interesting ideas!