Good day to all. The author of the channel "Bearded farmer \ Bearded farmer" today will show how he and his assistants gathered such a greenhouse.
The materials they used to build the greenhouse.
Wooden beam.
Board.
PVC pipe.
Wood screws.
Metal fastening tape.
Fixing corners.
Door and window hinges.
Steel cable.
Covering film - 120 microns. (Perennial.)
Plastic buckets.
Pieces of metal pipes.
Old boards.
Compost.
Cement.
Scotch.
Instruments:
Shovel
Screwdriver
Wood hacksaw
Roulette
Metal file
Rake
Hammer.
The first step was the anchor foundation. The buckets were filled with cement mortar, and a small piece of metal pipe was installed in each of them. Then all these buckets were dug into the ground, approximately 1 m apart. The entire length and width of the future greenhouse.
After the beds were made. To do this, they dug trenches and filled them with old boards and compost, then they covered it with earth.
Then the arcs of their PVC pipes were installed.
Next, the installation of a wooden frame.
Bottom harness.
At the ends, an oblique strut is required.
All metal parts were wrapped with tape.
Further windows were made.
The distance between the arcs is approximately 1 m.
The distance between the central pillars is about 4 m.
The pipes were additionally tied with a cable.
The height of the greenhouse is about two meters.
Then they covered the frame with film, and installed windows.
After well shed the beds with water.
An additional stretching of the end walls of the greenhouse was also done with a cable.
Then planted seedlings.
Buckets of water in greenhouses for irrigation, and they also serve as heat accumulators.
It’s still cool, so a general decision was made to additionally cover the seedlings with a spandbond.
And here is the result of the labors.
He did not take long to wait.
And met all expectations.
A good greenhouse was obtained by the author and his assistants.
Thanks to them for such a useful homemade.
And that’s all for me. Thank you all and see you soon!