» Fishing »Bait" Croatian egg "with your own hands!

DIY bait Croatian egg!


Hello fishermen, today I would like to show how to make a Croatian Egg bait. This bait is needed for very dense vegetation. This bait has a single or double hook, which makes it practically unengaged. Despite the fact that such a bait is easy to order on the Internet or buy in a fishing store, many anglers make it do it yourself. An important reason for the manufacture of bait on their own is the simplicity of technology, as well as the availability of materials and tools.

Tools and materials

- Champagne or wine cork
- drill
- Emery paper of different grit
- nail
- Paints
- Varnish
- Nail polish
- Double or single fishing hook
- Saw for metal
- Paper clip
- solder
- soldering iron
- Soldering acid
- epoxy resin

Take a cork from champagne or wine, I took one



We need the cork to increase in size. To do this, take our cork and throw in boiling water for 3 - 5 minutes




After that we take out the cork and see that it has slightly increased in size



Next, stick a nail into the center of the cork so that it comes out on the other side




Clamp a nail with a stopper in a drill



Next, we take sandpaper with a grain size of about 80 - 100 grid



And we begin to sharpen our cork, giving it an egg-shaped




At the last stages of processing, we move from large emery paper to smaller



And so little by little our cork takes the shape of an egg



After we have shaped the egg, remove the workpiece from the drill





After processing with sandpaper, we will need to cut the workpiece along the center with a metal saw





Next, go to the fishing store and buy a double hook



Double hook must be soldered in the middle




When fitting in place, it is evident that the hook length is not enough



To increase the length of the hook from an ordinary paper clip, we bend this detail




Solder the resulting part to the hook. We do not regret solder!




Now the length is perfect



Further, the most important is loading. We cut small pieces of lead and insert them into the slot




Check in a pan with water




We dilute the epoxy resin and fill the slot so that the resin is thick, mix it with sawdust




After the epoxy hardens, sand the workpiece with sandpaper



Here is the workpiece obtained after grinding



Primer coating



Next, take car paint and paint the bait




To finish (eyes, top, etc.) we use nail polish



After painting, coat the workpiece with several layers of varnish



Here is a "Croatian egg" turned out



Have a nice fishing !!!
7.5
7.7
8

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose

We advise you to read:

Hand it for the smartphone ...