Finally, spring has come, which means that it is time to rest in nature, barbecue and so on. For lovers of grill, I suggest you familiarize yourself with this project. Homemade It is a simple and convenient oven for frying meat, vegetables and other products. The hob is easy to clean thanks to a well-thought-out drain, and the stove consumes very little wood. Everything is made of sheet iron, firewood is loaded vertically from the top of the stove. This is convenient, you do not need to constantly open the door, lay firewood and so on. Just insert the sticks vertically into the firebox, and they themselves will go into the firebox as they burn. As a result, fuel burns long and efficiently.
Under the hob, hot gases go through the maze, give off the heat of the hob, and only then exit the chimney. If this project interests you, I suggest that you familiarize yourself with it in more detail!
Materials and tools used by the author:
Material List:
- sheet metal;
- chimney;
- long bolts with nuts for the legs;
- a piece of a profile pipe.
Tool List:
- ;
- ;
- marker;
- (not necessary);
- heat resistant paint.
Grill manufacturing process:
Step one. Housing
First of all, we will assemble the furnace body, it is an iron box, which inside is divided by a partition into two parts, as a result, a labyrinth for gases is obtained.
A piece of the profile pipe is welded on the edge of the hob in the very corner, the hob must be welded hermetically. As a result, thanks to the profile pipe, we get a drain through which dirty water will drain when you wash the hob.
Step Two Chimney furnaces and chimney
There are two furnaces near the furnace, one is classically horizontal, it is needed to ignite the furnace. And when the draft is already formed, the door of this firebox can be closed and then firewood is loaded through the vertical firebox.
The vertical firebox is a rectangular pipe, it is made of sheet iron. To correctly bend a thick iron sheet, you need to make cuts in the necessary places with a grinder.
As for the chimney, it is needed to mount the chimney. To make such a pipe, you can cut a piece from an existing pipe, cut it lengthwise, and then squeeze and weld so that the workpiece goes inside the chimney.
Well, then we weld the pipes into place, after cutting through the holes in the furnace. The author hung the furnace door on a long bolt and nuts.
Step ThreeFeet and first start
We weld the legs to the furnace, their author made of long bolts and nuts. After that, you can start the oven for the first time. The vertical firebox needs to be covered, we install a chimney and we kindle the furnace through a horizontal firebox. When the draft has already started, you can heat the stove through a vertical firebox, feeding firewood from above.
Step Four Final touches and tests
At the end, we weld the handle to the furnace door and paint the oven with heat-resistant paint. As for the hob, it should not be painted, just grind the iron with a grinder, and cover everything with newspapers before painting.
The oven can be tested, we heat it and before cooking my food. Pouring water on the hob, temperature and water will do the job, the dirt will immediately wash off itself and will flow through the profile pipe to the ground. You can start cooking, the author easily boiled water and fried eggs. Also, the oven easily fries quite large pieces of meat. The only drawback of the design is that it is impossible to control the intensity of combustion. Unless, you can embed the valve into the chimney.
On this project can be considered successfully completed, I hope you liked the homemade work, and you found useful thoughts for yourself. Good luck and creative inspiration, if you decide to repeat this. Do not forget to share your ideas and homemade things with us!