» Topics » Advice »Thermal knife - easy. Simple and necessary tool

The thermal knife is easy. Simple and necessary tool


Home thermal knife for cutting foam, plastic, synthetic fabrics, etc. - buy or make do it yourself? The simplest thermorezak is easy to do at home. It will take you quite a bit of time on the strength of 30-40 minutes.



Using a thermal knife, cutting above the specified materials will become simple and quick. To create a device, we need very few waste materials and parts, namely:



1. Old soldering iron.
2. The bolt, depending on the size of the tip of the soldering iron, in our case, the diameter is 4 mm, length 40 mm.
3. Cloth from a clerical knife.
And these are all the necessary materials for our project, incl. Everything is not simple, but very simple.





The procedure for manufacturing a thermal knife:

1. We make a bolt cut along, to a depth of 30 mm.
2. Mark the canvas from the stationery knife, as shown in the video clip.
3. We cut the canvas according to our markup.
4. We collect the thermal knife.
5. Connect the tool to a power source.
6. Enjoy working with the new tool.



The entire process of manufacturing a thermal knife is described in detail in the video clip.
Good luck and success to you friends.

Suitable for topic

Related topics

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose
7 comments
Guest Vita
On this occasion, I want to share the latest creative solution. A hanger for trousers with springs caught my eye. Ready version of the cutter ..
due to sagging, it is better to have a voltage regulator
I pulled the spring, but the regulator, of course needed! smile
Guest Vita
For a long time I have been cutting a large heated wire (due to sagging it is better to have a voltage regulator). Shallow also, a thin blade. So far, not a single injury.
Had two serious injuries, scars so far!

In 99 percent of cases, when working with a small angle grinder I cut with one hand, holding the workpiece in the other ... I did not have a single injury ...
P.S. I have been cutting for many years. I always buy circles in packs of 50 pieces.
P.P.S. NOT RECOMMENDATION !!!! "To sing like that, twenty years must be learned!" (c) Comrade Byvalov. C / f "Volga-Volga"
Normal! I always work that way
Had two serious injuries, scars so far!
Themselves burn!))))
Well, I’m talking about the same thing, they burn, they also stink, and it’s very toxic! smile
1. Normal! I always work this way, even standing on a vise ....))))))))) (PS DO NOT REPEAT !!! All the tricks are performed by professionals!)))))
2. Themselves burn!))))
1. Blade treatment with a canopy grinder - not healthyaboutexactly!
2. Immediately it is necessary to provide for the cleaning of the blade from adhering particles of material. smile

We advise you to read:

Hand it for the smartphone ...