» Phones and tablets »DIY mobile phone stand

DIY Wireless Charging Stand

Hello dear readers andthe inhabitants of our site!
Often, when the phone is charging, many continue to use it to watch movies, etc. But the wires from the charger get in the way, and I want to conveniently place the phone on the table.

In this article, the author of the thosa YouTube channel will tell you how he made a simple stand with wireless charging for his phone.

Materials
— 
— 
- Maple boards
- Double-sided tape
- Sandpaper
- PVA glue
— .

Instruments, used by the author.
— 
— 
- Drilling machine
- A circular saw
— 
- Ruler, square, pencil, knife, chisels, tape measure.

Manufacturing process.
So, all you need to make a stand is a couple of boards and. If your phone cannot charge in this way, then this problem can be solved by installing a special one in it.

The author measures the size of his phone, and transfers it to the board with a margin of 10 - 20 mm. Cuts on a circular saw.




In the center of one part marks the contours of the panel with the connector.





On the second blank marks a groove for the phone, and cuts it out on a circular saw.




Then glues the workpieces to the workbench using double-sided tape.


Using the router, selects a groove for the panel. The edges are ground.



The author did not guess a little with depth, I had to re-set the cutter, and make a selection.


In the center of the groove makes a pilot hole, and then drills another larger one, with a Forstner drill.


Also drills a hole for the wire.


All sharp edges are smoothed out with sandpaper.


Since the panel did not fit completely in the workpiece, you have to cut the edge.


On a circular saw, cuts the bottom of the workpiece at an angle.

Combines both workpieces, marks out and selects the missing piece for panel installation.



Now the panel fell into place.



The master glues both parts, and removes excess glue.




After the glue dries, it impregnates all surfaces with linseed oil.




Passes a wire through the hole, connects the panel.A large hole is needed so that it can be removed from the stand.



That's all, now you can put the phone on charge.



Thanks to the author for the interesting idea of ​​a stand with wireless charging!
All good mood, good luck, and interesting ideas!

Author video can be found here.
6
7
7

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose
4 commentary
Author
Hands are also free xaxa
Well, what movies should I watch at home on a smartphone? scratch

Those for which mom scolds ...))))
Author
Some listen to music through him, giving out bluetooth speakers.
Often, when the phone is charging, many continue to use it to watch movies
If my phone is charging, then I'm home! Well, what movies should I watch at home on a smartphone? scratch

We advise you to read:

Hand it for the smartphone ...