Surely, you all know how difficult and inconvenient to wear rubber gloves.
In this article, the author of the “create” YouTube channel will tell you how he made a device that will speed up and facilitate this process several times.
This homemade product is very simple to manufacture, and can be repeated even inhome conditions.
Materials
—
- Plastic bottle
- Steel clamps
- PVC pipe
-, tee
—
- Battery holder, snap button
- Insulation tape
- Corrugated cardboard.
Instruments, used by the author.
—
—
—
—
—
- Nippers, marker, screwdriver, knife.
Manufacturing process.
Usually rubber gloves are worn with great difficulty. The author is tired of this situation.
He cuts off the bottom of a two-liter plastic bottle.
As stiffeners, he inserts two steel clamps into the bottle.
Then cuts the hole for the clamping screw, and pushes it out.
Now, turning the screws counterclockwise, loosens the clamps inside the bottle.
Having fixed a dremel on a workbench with a clamp, he cuts off the ring from the PVC pipe.
He cuts it with nippers, tries on the inner diameter of the bottle. Removes the excess segment, and sets the ring inside the bottle.
In order to prevent sharp edges from damaging gloves and scratching hands, the author imposes a layer of insulation tape on them.
Removes the cork from the bottle, drills a hole with a diameter of 6 mm in it with a step drill. Then it inserts a silicone tube into the hole, and fixes it with hot glue.
Slices four squares of corrugated cardboard, cuts a hole in the diameter of the cork in three of them.
It connects the blanks with hot glue.
Inserts a tube, and presses the cork into place.
Now you need to make the upper part of the case, install a holder with a stopper on it. A tee with two tubes is connected to the main hose.
The author decided to use two vacuum pumps, and connected them to the hoses. I soldered the power wires to the pumps.
On the case, he installed the power button, connected the battery compartment, into which he put three 18650 batteries. He checked the operation of the pumps.
Then he made the base of the case, and put it all together.
For decoration, I glued insulating tape, and screwed the bottle into place.
Now everything is ready, and you can turn on the power of the pumps. The glove is put on the bell of the bottle, and inflated inside it.
It is enough to insert a hand into the glove, it is very easy!
Here is such a simple method of putting on gloves invented by the author.
I thank the author for an interesting idea that will be useful to both medical professionals and ordinary craftsmen!
All good mood, good luck, and interesting ideas!
Author video can be found here.