We are used to the fact that the stand for a smartphone takes up no less space than the smartphone itself, but the author of Instructables under the nickname chienline figured out how to make it look like a miniature trinket. The master made sure that she did not occupy the space behind the smartphone and under it, but connected to it from the side. Dimensions homemade the master adjusted the dimensions of the smartphone Sony Xperia XZ1, but it is possible to make stands for smartphones of other dimensions according to the same principle.
The wizard designs three parts for the stand: body, rotating part and axis. He sends the resulting files to the slicer:
And it prints with the following parameters: the thickness of the layer is 1.6 mm (accuracy is so-so, but it will print faster, however, the axis and holes for it will have to be adjusted), filling - 20%, with supports only from the surface. And now the details are ready:
The master warms the axis slightly, drives it, allows it to cool, and then collects the keychain:
If you print with a more accurate resolution, it is better to customize the file. So, the stand is ready, next to it lies a smartphone, while everything is flat:
But it is worth connecting them, and the result takes on a third dimension. There are two ways to install a smartphone in the stand. At the first, only the stand, lying horizontally, rests on the surface of the table, and the angle of the smartphone is adjusted:
In the second method, both the stand and the smartphone rest on the table, while the angle of the stand is adjusted, and with it the smartphone:
Well, for readers who do not have the opportunity to make parts with 3D printing, the same master here offers to make a stand from several sticks of ice cream, in which cuts are made along the thickness of the smartphone. There is no adjustment of the tilt angle, but the principle of operation is the same: the stand is attached to the side, and therefore when it is not used, it takes up very little space.
