Hello everyone, today I will tell you how the master did do it yourself a little table.
This table is built of natural pine without a single nail and screw or without other fasteners.
Instruments:
1. Pine
2. Drill
3. Grinder
4. Skin
5. Glue
6. Drill cutter
7. Measuring tape
Necessary materials:
To build a table, we need pine logs of about 5-8 cm. Using a simple knife or any other, you need to peel the skin from the logs. It is better to remove the skin on a long log, and then saw it to the desired size.
Step 1. Cut the legs of the desired size, four pieces of about 75 cm, two crossbars of 27 cm and two more of 100 cm.
Step 2 Next, you need to grind all the ends of the legs, which will be inserted into the grooves and glued, this can be done in any way you like.
Step 3 Drill the holes that hold the legs with a 5 cm drill pen.
Carefully drill holes, drill slightly at an angle so that the legs do not stand straight, but are slightly inclined. Before installing the legs, drill holes for the brackets for longer brackets, drill holes higher, and for short brackets, lower and also need to be drilled slightly at an angle.
Step 4 Lubricate all the grooves with glue, first you need to insert the brackets into the legs using a rubber or any other skein to hammer them into the grooves. Next, you need to insert the legs into the countertop also having previously missed with glue.
Step 5 The table is almost ready to check with a hammer the legs and crossbars for a tight fit and wipe off any excess glue. Turn the table over if it is uneven - it can be swayed a bit to correct irregularities until the glue has frozen, you can also use clamps until the glue dries.
The table is ready, now you can leave it this way or varnish for about 2-3 layers.