» Topics » DIY ideas »Network controller - SK-6F

Network controller - SK-6F

Topics / DIY ideas
Added 4 commentary
I developed the device to be used for the timely and safe shutdown of equipment, processing centers, numerically controlled machines, automated production lines, etc. The controller provides information about the state of the main and backup (generator or accumulated) networks. Generates commands for correct, without failures, disabling automation when changing network parameters. This is especially important during the process. For example, the workpiece is machined on a lathe. And at the time of an unpleasant event, the special outputs of the device can be used to form a command to remove the cutter from the working area and thereby eliminate the marriage of the product. The network controller (SK-6F) stores information about what happened to the network when it stopped. This allows you to analyze the nature of the malfunction and eliminate it in a timely manner. SK-6F is powered by a 24V source with an uninterrupted circuit. It is mounted on a rail in a cabinet next to the automatic and electronic equipment of the protected machine.



Question \ topic is automatically published in the social. site network - stay tuned for answers there:
0
Added 4 commentary

Suitable for topic

Related topics

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose
4 commentary
Author 0
Reply To quote A complaint
Korolev,
The reaction is almost instantaneous, (see passport), since this scheme was developed taking into account the operation of machines with thyristor converters still used. New machines in production with synchronous drives have a much greater tolerance and everything is easier there ....
0
Reply To quote A complaint
Razrabotchik,
When a critical undervoltage or overvoltage occurs in the main network
To what extent and at what time intervals? scratch
Author 0
Reply To quote A complaint
Pronin,
No, not from the battery. Most machines have their own - 24v. with backup battery for CNC. The green LED indicates that everything is normal. When a critical undervoltage or excess occurs in the main network, it goes out and the red LEDs corresponding to the emergency light up. The process of the machine stops. If a backup network fails or crashes, the yellow indicator lights up, information is transmitted to the remote control or the CNC system, while the machine does not stop working and the operator decides to continue working or not. And in the photographs it’s just a glare, so I took it ...
+1
Reply To quote A complaint
"SK-6F is powered by a 24v source with an uninterrupted circuit." Is it from the battery?
The lamp on the "Accident" is usually put Red.
The disk (hard drive) is similarly made for outputting heads.

DIY categories

We advise you to read:

Hand it for the smartphone ...