» Fixtures »Paracord case for multi-tool

Multi-tool paracord case













A man must protect his instrument. I will show how to weave a multi-tool case. I have model Mini Multi-Tools Leatherman PS4.

Step 1: Weave the cobra harness







In the same way (weaving a “cobra”), how do you weave a paracord a braceletneed to weave a tourniquet.

Step 2:







The harness will be used as a frame, the basis for the cover.

Step 3: Length







Make sure that the woven tourniquet is long enough so that they can wrap the multitool around the perimeter, or rather two long sides and one end. The second end must remain open.

Step 4: Sidewalls







With a special paracord needle, thread the lace onto the edge of the cover, as shown in the photo.

Step 5: Sidewalls







Stitch the side with stitches, starting from the top to the bottom, then go to the other side and sew it from bottom to top.

Step 6: Fit







Go on ...

Step 7: Trying

Multi-tool paracord case




Place the tool inside the cover, you can slightly relax the side trim if the cover is too large, or vice versa, pull it so that the cover fits snugly against the knife.

Step 8: Finish

Tie the ends of the side thread, cut off the excess and burn the edges with a lighter.

Step 9: Voila!









Surprisingly, this case also came up with the multitool Gerber Dime.
10
10
10

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose

We advise you to read:

Hand it for the smartphone ...