Today, the most effective and cheapest way of fishing is fishing on the lantern, which is characterized by high functionality, simplicity and convenience. I would like to note the fact that fishing for a lantern in winter is significantly different from summer fishing. Another advantage of female girders is fishing in hard-to-reach places, such as barrels and whirlpools, as well as where fishing with a simple fishing rod is impossible in principle due to strong vegetation, inclined trees or bushes. For example, on a small but very thick river, spinning will not bring good luck, even if this river is teeming with fish.
The manufacturing process of this unique gear, which will be discussed below, is quite quick, simple and practically does not require any costs.
Making a zerglas
The most optimal material for the manufacture of the zerglas is an ordinary PVC pipe with a diameter of 32 millimeters, which is used for laying sewers and costs no more than fifty rubles. One 2-meter pipe is enough for the manufacture of eighteen such gear. So, we cut the pipe (you can use a hacksaw for metal) into 10-cm cylinders. We clean the edges with a skin and remove the chamfer (you can use a "medium-sized" file or emery).
Next, using a hot nail or drill, at a distance of about 1.5 centimeters from the bottom edge of the workpiece, we burn one through hole. We perform the same procedure with the upper part of the cylinder, but here we are already doing two through holes opposite each other. We will use the bottom hole for the stopper scaffolding, made of a simple but strong wire with a diameter of about one millimeter, which is subsequently bent with the letter "P". You can also use a cork fuse from under the champagne, the main thing is that the stopper does not inhibit the fishing line when it escapes from the tube.
Next, you should make a suspension from the same fishing line that will be used in our zergilka for hanging it from any rod, rod, bush or any other more or less solid vegetation. For this, the suspension must end with a loop (noose).As for the main fishing line, here, for most ponds, 10 meters will be quite enough. If fishing will occur in dense vegetation or under snags, part of the forest can be fixed using tape or tape, leaving a reserve of 4-5 meters.
At the last stage, it remains to fix the freely sliding sinker-olive, which is hung on the free end of the fishing line, tie a 30-centimeter loop and put on a tee. I would like to focus your attention on the absence of a metal leash in the ventilator, which significantly increases the catchability of our gear.