Many of us love computer games. More recently, we enjoyed a simple eight-bit pictures in the games of the good old consoles. Today, however, game graphics are striking in their realism, and the question arises - what if this realism is not only at the visual level, but also at the level of sensations? Is it possible to have a mouse that will simulate the real return on firearms when we play our favorite shooter? You can not only have such a mouse, but also make it yourself.
Making a vibro mouse in a video clip:
[media = http: //www.youtube.com/watch? v = YCKbE57OTag]
To do this, we need a burner or a lighter, a switch that can be taken from any children's toy or an old radio player, a computer mouse itself, a dowel or a nail, a vibrator from an old mobile phone or a motor from some old toy, a glue gun and a screwdriver. It is recommended, of course, to use a vibrator from a mobile phone, since it has a relatively small size, it only needs 3.7 volts to power it, while the mouse tries from 5 volts, which allows the motor from the phone to accelerate even faster. First, you need to solder the two wires to the vibrator of the phone, which in addition to its small size has a built-in imbalance, while on an ordinary motor you need to create an imbalance manually.
The first step is to disassemble the mouse. After disassembling, it becomes clear that there are three contacts in the lower part of the left click. One wire from the motor must be soldered to the middle pin.
The second wire of the vibrator must be connected to one wire of the switch. At the same time, polarity has absolutely no meaning. It doesn’t matter which wire will be positive, and which will be negative, since this will only affect which way the motor in the phone’s vibrator will turn. The connected wires must be insulated with a glue gun.
The second wire from the switch must be connected to the connector from which the multi-colored wires go. In our case, it must be connected to a red wire. Solder these wires very carefully so as not to hurt or damage neighboring ones. Again, at the end, isolate everything with a glue gun.
The mouse is ready. It remains only to assemble it, having previously measured all the parts so that the vibrator does not touch the mouse body itself. The best option would be to stick in the middle, based on the mouse.
Finally, you should heat the nail with a burner and make a hole on the side of the mouse body to place the switch there.