» Fixtures »Homemade hot wire stand

Homemade hot wire stand

How to do do it yourself lightweight, durable and elegant stand for hot pans and pans?

For this crafts, the manufacture of which is not difficult, you will need 2.5 meters of copper lacquered wire with a diameter of about 2 mm (in its absence it can be made from another soft wire).

First you need to fold this wire in half, fix one end on a stationary object, and twist the other by rotation until it is curled to its full length. It is better to do this with any drill or rotor. The frequency of the curling step should be uniform and smooth, as in the photo

Next, the resulting twisted wire is once again wound onto the plate. You can use a plastic ruler, as in the example

We do a wave to the very end of the wire

Now carefully remove it from the ruler

The resulting spiral needs to be developed as in the photo


Rough ends bite with side cutters

Make a ring out of a spiral, and merge the ends of the wire and wrap them with thin wire.

Can solder

Align the ring in one plane and paint over the joint.

You can use it.

Your table top will be protected!

Good luck to you!
0
0
0

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose

We advise you to read:

Hand it for the smartphone ...