Half of the inhabitants of the earth cannot unlearn the harmful habit of smoking. But smoking simple cigarettes is one thing, but smoking good, fragrant tobacco is a completely different thing. Hookah can not be abused, but sometimes for a little pleasure you can afford nice little things.
Let's watch the author’s video:
For a hookah you will need:
- flask;
- mine;
- tubes;
- a bowl for tobacco;
- food foil;
- coconut coal;
- toilet paper;
- tweezers;
- tobacco;
- paper clip;
- canvas;
While the hookah itself will be made, you need to heat the coal itself. To do this, turn on the gas burner and at the end of the canvas we bring the coal to warm up for 20 minutes.
Now it's up to the tobacco. To begin with, we need to squeeze the amount onto a sheet of toilet paper with a needle, this can be done with your fingers, but then they will need to be washed. We close the remaining tobacco in the packaging and seal it again in a box so that it does not disappear.
Then we wrap the tobacco in a sheet of napkin or toilet paper and begin to squeeze it tightly in your hand. This is done in order to remove excess juices from tobacco.
Now it can be put in a cup. The main thing here is that the tobacco does not stick out through the top and does not start to burn.
Now we tear off the foil and turn it into two parts. The main thing is that the part is matte, otherwise the shiny one will reflect all the heat.
With foil we completely cover the bowl with tobacco. The foil should be fully pressed against the bowl and not let air into the side slots. The foil on the surface must be well leveled.
The next step is to pierce the top of the foil with a needle. We should get a lot of small points. In the center we make a puncture a little more.
Next, you need to attach a cup of tobacco and foil to the mine itself. All this should sit tight and the air should not go anywhere.
Now we are pouring water into the flask. It is necessary that the tube from the shaft is submerged by 1.5-2 centimeters.
Next - connect one or more hoses, depending on how many hoses the shaft itself is designed for.
After the hoses are attached, you need to make a foil cap. It retains heat and protects against fire.If you are against the cap, then you can not do it.
The cap we have will be a piece of foil that covers the cup. At the bottom, our cap should be firmly pressed against the cup, and at the top should be completely straightened.
The time has come for coal. In 20 minutes it warmed up well and you can start crumbling it.
When we crumbled the coal, we need to place it on the foil of the cup and start lighting it. To quickly lighten, you can close the cap with your hand or with any lid, but coal emits heat and therefore it is better to close the lid.