Everyone has documents, ciphers and money that we need to hide from prying eyes. At the bottom of the flower pot you can even hide gold chains or earrings.
The manufacturing process itself is not as complicated as it might seem. Let's watch the author’s video.
For a flower safe we need:
- a small flower pot;
- a jar of vitamins;
- many different screws, screws, bolts and nuts;
- a plastic circle, can be cut from a mayonnaise can;
- glue gun;
- boron machine;
- nozzles for cars, grinding and drill;
- a jigsaw.
To get started, prepare a place where you will have a safe. It can be a windowsill, a table edge, a chest of drawers.
Let it be a table. We put a jar of vitamins on it and circle its bottom with a felt-tip pen. A circled circle should remain on the table.
Now we need to take a drill and make many holes in a circle with a drill. We make holes the way we need to cut this circle, and the jigsaw does not cut very well in corners.
Now we take a jigsaw and cut this circle from the table. As a result, we should get a through hole in the desktop.
Now we check that the jar gets in there. If the jar climbs very badly, then we need a bor machine with a grinding nozzle. We need to make the jar freely enter and exit. The jar should enter easily enough, but at the same time, the hole should not be too wide, the jar in it should be stuck, but pass.
Now we proceed to the assembly of the safe itself. If you have a pot with holes at the bottom, then we attach our plastic circle to it. For pots that do not have holes in the bottom, no circles are needed.
To glue the circle, use thermal glue. The circle must be glued to the outside of the pot.
If you have some kind of pattern on the plastic, then it can be cleaned off with a grinding nozzle.
Now we need a cork from a jar of vitamins. We apply thermal glue to it and glue it to the bottom of the pot.
Drill 4 holes on each side of the pot (west, south, east and north). Holes should be at the junction between the bottom and the wall.
Now we take a jar of vitamins, put there, some kind of treasure and twist the lid glued to the pot.
We insert the jar into the cut hole.
Now we take the screws and screw into those 4 holes that we drilled in advance.
We put a lot of glands, bolts and gadgets on the bottom of the pot.
You’ll have a pot on your table that will contain a lot of bolts and gadgets. If someone asks why you screwed it, it’s fashionable to answer that you’re tired of the fact that the pot is constantly falling and the bolts are scattered.