If you need to make firecrackers from old empty sleeves. But when you fall asleep the powder in them you are already quite fed up constantly pushing it deeper with a toothpick. Then you need a device that will help you quickly and evenly distribute the gunpowder on the sleeve, and several pieces at once. In this case, a small vibrating table created by do it yourself from improvised means. On it you can fix several dozen shells at the same time and distribute the powder in all evenly and simultaneously.
Let's get acquainted with the manufacturing process homemade in the video:
[media = http: //www.youtube.com/watch? v = L72VxHlcL4w]
For work it is necessary to prepare:
- 2 plastic planks or thin sheets of plywood;
- Double-sided tape;
- self-tapping screws;
- screwdriver;
- glue gun;
- 9V battery;
- vibration motor;
- 4 springs;
- 4 small sleeves.
When everything needs to be prepared, you can begin to work.
So, first of all, we need to take one plastic plate and fasten it with a screw and a screwdriver to the workplace. Two mounts diagonally apart are enough.
After that, we will need springs that you can get from old fountain pens. Since their length is not enough for us to create a mini vibrating table, we will lengthen them using small sleeves. Pour some glue from the glue gun into the sleeve and insert the spring there. Lightly fix with your fingers so that it becomes even. Exactly the same manipulations are carried out with the rest of the liners and springs.
When the designs are ready, glue them with the same gun at the corners of the plastic board, with sleeves to the surface. We give the glue a chance to dry.
Vibromotorchk can be removed from the Sony playstation or any other unnecessary remote control, razors, brushes, in which there is such a device. We solder the wires to this vibration motor contacts, and on the other hand, a mount for a nine-volt battery.
Now you need to take a second plastic board, check how it becomes on the springs. If all is well, then we take a vibromotor and put it in the middle between the plates, while checking that it is not clamped by them. After that, glue the vibration motor with a double-sided tape or glue gun to the center of the unfixed plank. If we attach to glue - we are waiting for it to set.
We use glue again to glue the loose plate to the springs that are already fixed on the second plate. We are waiting for the glue to dry.
We connect the battery to the vibrator and make sure that everything works as it should.The mini vibrating table is ready.