How to make a vibrating toothbrush with your own hands

In today's world, most people are accustomed to almost everything homework affairs are performed by household appliances. Recently, electric toothbrushes have become very popular. Which, according to scientists. I can whiten my teeth and get rid of tooth decay. They can be purchased at almost any city pharmacy. However, they are not very cheap, and not everyone can afford it.

Why spend a lot of money on something that can be easily constructed at home?

We suggest you watch a video that clearly shows how you can make such a toothbrush at home



To make a vibrating toothbrush we need to prepare:
- electrical tape;
- Toothbrush;
- a cover from a plastic bottle;
- old charger or power supply;
- motor;
- awl;
- soldering iron;
- a knife.


The motor must be taken at 3 V or 9 V, preference should be given to small motors, which are most often found in phones for vibrating alert.

When everything is necessary to create a vibro-brush is ready, get to work.

First of all, we take our bottle cap and, exactly in the middle, make a hole. The hole can be made with an awl, but if you don’t have one at hand, use the sharp end of the motor.


We take the old charger, if there is no small power supply, we cut off the tip of the part that connected to the phone, we clean the wires. After that, the wires are neatly soldered to our motor or attached with a glue gun. Do not forget to take into account the polarity of the wires during connection.


By the way, a hole in the lid, in the absence of an awl, will be made much easier if the motor is already connected to the old charge and can be connected to the network.


At this time, you can see that the end of the motor located in the opening of the lid already transmits vibration to it, but this is very small.


To increase vibration, cut off half of the cover. It is only necessary to cut off by moving the cut line slightly to the side so that our small hole remains intact.We put part of the cap with the hole on the end of the motor.


Using electrical tape, we attach the handle of the toothbrush to the motor case so that its bristled part is directed in the opposite direction from the cut off cover.


Now the vibrating toothbrush is ready, it remains only to connect our product to the network.