You do not know where to use the old trash, namely hard drives from computers, which, in fact, you no longer need, but it is a pity to throw them out.
Watch a video on how to make a case for bits yourself do it yourself
We will need:
- plastic from an old suitcase;
- ruler;
- several old hard drives;
- screwdriver;
- cutter;
- steel plate.
To begin, disassemble the hard drive. The hard drive mount rests on screws that come in stainless steel.
Open the hard drive case with a knife. Inside, we also unscrew all the bolts.
Remove the steel plate.
Under the coil is a neodymium magnet, which has high power. You can’t definitely say how many magnets you can remove from the hard drive. The manufacturer inserts one large, two medium or 4 small magnets.
We take a sheet of plastic and its mode on rectangles. You can cut with a conventional cutter made from a hacksaw blade.
Now we glue the pieces of plastic together. You need to glue the pieces one on one.
You should get 5-7 pieces glued together. After that, squeeze the pieces of plastic with any heavy object so that they are easier to fasten. Under pressure from a heavy object, pieces must be left to join for several days.
After three days, we take off our cargo. If the plate sticks together and excess glue or broken plastic comes out, it must be processed.
If there is a lathe, then process the sides of the plastic to get a flat surface.
Now in a piece of plastic we drill a hole for each bit. All openings should be parallel and at the same distance.
Now, glue a strip of the same plastic along the edge.
From the edge where we glued the strip, we insert magnets.
So that the magnets do not fall out and work well, we insert a steel plate to the magnets.
All the holder for the bits is ready, it can be used anywhere, and now the cue-balls will not fall out of your suitcase.