Manufacturers of mobile phones no longer include a separate USB wire in their package: chargers are available with USB connectors, which saves money, because there is no need to release a separate wire. In addition, manufacturers save on the length of the wire, which causes difficulties when charging, since the length is not enough to put a mobile phone on a shelf or table. The solution to the problem may be the manufacture of a special shelf for charging, which we will do right now.
Before you start making shelves, we suggest watching a video:
So, we need the following components and tools:
- a piece of plastic pipe, which is used when installing the drain;
- building hair dryer;
- engraver
The author uses an engraver to cut the pipe along. Not everyone can have an engraver, so a hacksaw can be an alternative. Cut the pipe along.
Now we need to align our pipe. To do this, heat it with a building hairdryer.
Next, round the corners of our plastic piece. You can round corners with ordinary scissors.
At this stage, we need to determine the center of the plastic piece in order to make a hole on its upper part. To do this, you can use the most common ruler and marker.
Now you can begin to form the shelf on which the mobile phone will be placed. To do this, we again need a building hair dryer.
In order for the mobile phone not to fly off the shelf, you need to bend a separate small side in the front. Again, warm up our piece of plastic along the fold lines. To form right angles we use two boards.
This simple construction works according to the following principle. The shelf is suspended on the mobile phone charger itself. To do this, we made a hole, and on the shelf at a right angle put a mobile phone. The side that we bent in front does not allow the gadget to fly off. The design turned out to be simple and stable.
If desired, you can modify the shelf, for example by painting it. We’ll add from us that you can also set the backlight, stick stickers.Simply put, use your own imagination.
