» Car DIY » Bicycles »Making a taillight on a bicycle

Making the taillight on a bike


Bike Always been popular all over the world. Especially today, when pollution of the planet and endless traffic jams cause numerous inconveniences on a global scale and scientists insist on the need to reduce the number of cars on the streets, the bicycle takes on a new life. If you are a lover of bicycles and prefer a bicycle to other vehicles, then you will definitely like this material, because in it we will consider a method of manufacturing a rear marker light for a bicycle.

We offer you to see the video on the manufacture of headlights



So, what we need in the manufacturing process:
- battery compartment for the crown;
- crown battery;
- mount from reflectors;
- LED strip red;
- drill;
- drill;
- bolts;
- nuts;
- washers.

Immediately clarify the need to use the battery compartment for the crown. The fact is that such compartments have special contacts for connecting batteries such as crown. In addition, they have a switch that allows you to turn the flashlight on and off at the right time without any problems. As for the LED strip, for the manufacture of the flashlight we will need 3 pieces of 5 cm each. There will be no special problems with finding materials, so you can proceed with the assembly.

First of all, we need to take care of the mount. To do this, drill two holes on the back of the battery compartment. The same holes are present on the mount.

Next, we fasten the mount to the battery compartment with bolts with small heads. Bolts with small nuts are necessary so that the battery in the compartment does not protrude and does not interfere with the lid closing.

Now we need to stick the LED strip on the surface of the battery cover. However, before this we take care of the blanks from the tape. We cut three pieces of 5 cm and strip one end of the silicone coating to release the contacts.

The next thing to do is to solder the pieces of LEDs together and glue them on the compartment.

At the end, solder the wires coming from the battery compartment to the LED strips.For convenience, you can solder the wires to the extreme contacts, and connect the middle ones to each other.

Our headlight is ready. You can safely install it on your favorite bike and ride it at night, without fear for your own safety.
0
0
0

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose

We advise you to read:

Hand it for the smartphone ...