Making a headphone stand

High-quality headphones are an integral accessory for every gamer, as well as a specialist engaged in video and audio editing. Any high-quality headphones need special care. The main role in this care is played by a good stand, which allows you to always keep the headphones near the computer. A good stand, of course, can be purchased in specialized stores, but we suggest that you do not bother with long shopping trips and spend a few minutes viewing this material, in which we will consider how to make a headphone stand in home conditions.

First, check out the homemade stand video.



We will need:
- ruler;
- a pencil;
- two metal pipes;
- a small log in the form of a cylinder;
- square block of plywood;
- paints;
- saw;
- drill;
- drill

First of all, we need to mark the square bar in the middle.

Next, we need to cut the square bar according to the markup made in the previous step. To do this, you can use a conventional saw.

The author does not show the cutting process, however, from the figures below it can be seen that he also sharpened the corners on the drilling machine with a nozzle from the skin, getting beautiful edges.

Next we need to drill holes on the casts. This should be done on the sides strictly in the middle. To do this, we first mark the middle, and during the drilling process we wind the tape on the bars so that they do not break.

On each bar, we got two holes.

Poke metal tubes into the holes made. For greater stability during the assembly of the structure, slightly hammer the pipes with a hammer. You need to do this one at a time.

Next, we drill a hole on the upper bar and fasten the bolt, on which we fasten a small piece from a small log in the form of a cylinder, on which we will hang the headphones.

Next, we paint the resulting structure with ordinary spray paint. The author uses silver paint, but here it is a matter of personal taste and personal preference.

The headphone stand is attached to the side of the computer table with two screws.