It's no secret that the water that flows from the tap, to put it mildly, does not meet the standards safe for the human body. Gone are the days when it was possible to boast, saying that you open the tap in the kitchen and the water flows - it takes the second place in the world, as in the good old film "Mimino". Today we are forced to go to the store and buy bottled water, thus overpaying for ordinary drinking water, which our body needs. But we offer a completely budgetary solution to the problem.
You can familiarize yourself with this solution in the video, after which we will make the text review useful. homemade
So what we need:
- plastic bottle;
- stationery knife;
- glue gun;
- filter.
According to the author of a homemade teapot that filters water, the filter can be purchased in specialized stores for about 200 rubles. Also, if you don’t have a glue gun at home or even in stores, as in the case of the author of the homemade product, then you can safely replace it with rubber waterproof glue. Let's get started.
The bottle must be cut according to a certain scheme, which is presented below. You can also take a look at the markup made by the author of the video.
The straight cut line should be slightly above the middle, but not very much. With a clerical knife, we cut the bottle along the line, trying to do it extremely carefully and evenly. If it doesn’t work out very evenly, you can slightly trim the edges with small scissors.
We also cut the top of the bottle to the diameter of the filter. If you plan to make a reusable kettle with the possibility of replacing the filter, then you need to cut it so that the filter enters the hole as tightly as possible. If there is no desire to mess around, then you can just stick the filter with a glue gun or rubber glue.
We also make a hole at the bottom of the middle cut on the bottom of the bottle and cut the neck with a stopper.
Put the top with the filter in the bottom of the bottle. The upper part can also be glued for greater structural reliability.
Finally, glue the neck to the hole on the side.
Our simple design is ready.The filter kettle works as follows. Water that pours from the top passes through the filter and accumulates in the bottom of the bottle. After that, it remains only to open the lid on the side, pour the filtered water into a glass and enjoy clean water.
