After a successful repair, the question always becomes of acquiring lighting fixtures. We bring to your attention a method of manufacturing an unusual and very beautiful lighting device that can be used not only as a sconce, but also as a chandelier.
Necessary materials
• Oak boards - 2 pieces, (dimensions 12x18x2400 mm)
• Glue for wood
• Soldering iron
• Sandpaper
• LED strip (1m)
First you need to prepare all the parts of the future lighting fixture. You should get 4 squares and 5 triangles. For triangles, strips of oak planks should be cut.
The dimensions should be as follows: 10 pieces of 14 cm and 5 pieces of 17 cm. For squares, 16 strips of 14 cm each should be prepared. Corners should be cut so that the parts fit easily into a shape.
Sand the strips using sandpaper.
Glue all the strips into the figures using special glue and set aside until completely dry.
It is necessary to make holes in the figures (two in each).
From the remaining boards, cut two sticks, the diameter of which should correspond to the size of the holes in the figures.
Then we put all the figures together in one design, while alternating triangles and squares. Connect using two sticks.
21 cm of the LED strip should be cut off and glued to the inside of the lamp.
It is necessary to solder the wire to the LED strip.
Awesome lighting fixture is ready. It will surely cause real admiration among your friends and acquaintances.
