Many thought to buy a boron machine. But not everyone can afford it, since it is not cheap. I also thought a lot to buy it or not, and so I decided to make it do it yourself. And if you do not know what to do, do not despair. Today I will show you and tell you how to make a boron machine from practically available tools. Well, of course, this drill machine will not be as powerful as a store one, but it can be easily polished and cleaned up with small items. And at the same time it will cost you cheaply.
Materials and tools required:
- soap jar
- motor
- power supply on 9-V
- power button
- drill
- wiring
- hacksaw
- stationery knife
- chupa chupsa tube
- glue
Step 1: We take a jar from under the soap bubbles and cut off the bottom of it with a hacksaw for metal.
Step 2: Cut a small window under the switch using an office knife.
Step 3: A small hole should be made into the covers for the wires.
Step 4: Now let's do the wiring.
Step 5: Thread the wires from the power supply through the cover. Solder the wire from the power supply and from the motor to the switch. About the other motor wire to the power wire.
Step 6: And install the motor. If the jar is slightly wider than the motor. You can make a lining, as in my case.
The lining can be made of electrical tape or tape.
And so it turned out it remains to make a nozzle.
Step 7: We take any wooden stick and make a keg, and in the middle we drill a through hole of the same diameter as the chupa chupsa stick. Insert the stick into the hole and glue it with a barrel.
Step 8: Make a strip of sandpaper and glue it on the barrel.
And our bor machine is ready!