Today, the author will tell us how to do it yourself at home. device in order to get a tattoo on the body.
First, I suggest you watch the author’s video about the craft:
Many people, regardless of their faith, wealth, age, one way or another want something to express themselves, to be different from another gray mass of people. All this is done in different ways: some dye their hair, do piercings or enter into one of many subcultures, and some make tattoos. This expression is welcomed by few, but still there are such people. Making tattoos in special schools is a very expensive pleasure, so I want to show the manufacture of a homemade device - a tattoo machine.
To make the device, we need the following components:
- helium pen;
- pen or aluminum wire (approximately 12 cm;
- a motor (for example, from a tape recorder or a toy car), the more powerful, the better;
- guitar string;
- Power Supply;
- electrical tape;
- lighter;
- sandpaper or a small grinder.
We proceed directly to the manufacture.
First, take a pen, light a fire, and use it to bend a pen:
Next, with pliers, “flatten” the bent tip of the handle:
On the motor you need to attach an eccentric or gear and fix everything with a glue gun:
Cut one half from one handle and use one tape to tape one handle to another:
You should get such a construction here:
After that we take a small piece of a metal stick, heat it up on a fire and carefully “fuse” it into the eccentric:
After that, we glue the flattened part of the end of the handle that we made at the very beginning of manufacture with glue crafts and gently glue the motor to the handle:
We take the string and pass it through the eccentric and through the handle:
Pull the string on the eccentric and fix it.
Using a spot soldering iron, we fix the wiring from the motor:
We need a power supply with wiring, which you can remove from charging to the phone.We attach the wiring from the charging socket to the motor, and from the wiring motor we connect to the wiring leading to the plug and then to the outlet:
Using glue, we attach our nest to the back of the flattened end of the handle:
Carefully isolate all the wires:
That's all. The device is ready, now with the help of a grinding machine or sandpaper we make the pen tip sharper and you can start drawing on the body:
Here is such a design we got the result: