Fragrance in the bathroom can be a substitute for regular aerosols. This will save a lot of money that were spent on the regular purchase of these particular aerosols for the bathroom.
Let's start by watching the author’s video
So we need:
- cooler;
- cardboard box;
- switch;
- contact battery crown;
- crown;
- marker;
- stationery knife.
First of all, you need to cut a hole on a cardboard box so that a cooler is glued into this hole. To do this, make a mark with a marker or pen, and then cut a hole with a clerical knife.
When the hole for the cooler is ready, we need to connect the cooler itself. However, first you need to deal with the wires. There are three on the cooler, but we need two. The yellow wire is redundant, so it can be cut off.
Thus, we get red and black wires, which are plus and minus, respectively. We start the connection with the switch. We make two holes for the wires on the back of the box. We connect black, that is, the negative wire to the switch.
After that, you need to connect the crown contact, observing the polarity. We connect the negative wire from the crown contact to the free contact of the switch.
Free wires are soldered to each other.
We must isolate the wiring to protect the structure from circuit.
Now we make a place for the battery and the switch. The switch can be attached to the hole on the bottom of the box with a glue gun.
Finally, we glue the cooler in its place, after which we connect the wires to the power source. The author of the idea uses a crown-type battery as an example and advises using a different power source.
Holes need to be made on the back of the box so that air is drawn in through them.
For the construction to work, we pour in an ordinary cork from a plastic bottle an essential oil or any other odorous substance and put this cork in a box behind the holes made.
Turning on the design, the cooler will begin to blow air, which will be freshened with essential oils installed inside.