Long trips, hard working days: all this leads to fatigue, which can be removed by a relaxing massage. However, not everyone can afford to go to the massage parlor, so you have to look for alternative solutions. We devoted this material to just such a decision, in which we will consider the method of hand-made manufacturing of a vibro-massager for the body.
Let's start production by watching the author’s video
So we need:
- nozzle for hair dryer;
- box for finger batteries;
- vibration motor;
- a piece of rubber;
- switch;
- pieces of wiring;
- plastic clamps.
According to the author of the idea, the vibration motor can be purchased not only in markets and in specialized stores, but also on foreign Internet sites, such as eBay. There is a pair of such engines 3.5 dollars.
Start by disassembling the hairdryer nozzle. This is done without any problems with a small screwdriver.
Next, take a piece of rubber and cut to fit the engine. You need to get two blanks to put the engine between them.
Now we take a soldering iron and two wires. Solder the wires to the motor. For this, contacts are provided on the motor.
We take one plastic clamp with which we connect the motor with one rubber blank and a box for finger batteries.
We also install two plastic clamps between the rubber band and the battery box.
We install the design on the lower part of the nozzle for the hairdryer so that between the motor and the nozzle there is a second rubber blank.
We fix the structure with two clamps that are installed between the rubber band and the box.
At the top of the hairdryer nozzle, we make a hole for the button.
We check whether everything is correctly cut and go to the soldering of wires.
Finally, you can assemble the structure. We first install the finger batteries in the box, then collect all the wires inside the structure and fix the back of the nozzle in its place.
The resulting vibro - massager can be taken with you on the road, since it has small dimensions that give it portability.