We all made paper airplanes in childhood. In addition to the entertaining nature, such a hobby has an educational and developmental character, therefore, children must be taught this craft. To make the process of training and launching airplanes more fun, we propose to build a car that will allow you to launch these airplanes.
Let's start with the author’s footage
What do we need:
- wooden planks;
- marker;
- ruler;
- Super glue;
- a tape harness or a bicycle chamber;
- two disks;
- a plastic card;
- 2 motors.
First of all, it should be noted on one bar the gluing points of the other two. We will do this with a marker and a ruler. Next, apply a layer of superglue to the marked places.
Glue the strips on the base.
Next, take a tape tourniquet or a bicycle chamber and cut into two thin strips.
The next step is to glue the obtained strips along the entire circumference of the disk using superglue so that the rubber peeks out a little.
After that, take a plastic card, cut two small round pieces and glue them to the center of the disk.
We pass the holes in the center of the pieces of the plastic card so that the axis from the motor can be inserted through these holes.
We make two bases for a motor from pieces of wooden plank.
We glue the motors on the base so that the disks on the structure are practically in contact with each other.
We take a few more pieces of wooden plank and fasten them along the edges of the structure.
Next, you need to cut the plastic ruler into two parts along and stick them into pieces that were glued around the edges in the previous step, thus obtaining a guide.
It remains to connect the design to the power source. The author of the idea, for example, uses a battery from a screwdriver. From it you need to bring two wires and connect them to the motors.
In the end, it remains to glue the structure to the power source slightly at an angle and enjoy the launch of the aircraft.
