We present to your attention an interesting idea for the manufacture of barbecue from a car disk. The author of the idea claims that the use of the disk is justified by the fact that it is ideal because it has thick metal walls. Thanks to this, the grill will not quickly burn out from hot coals.
We recommend starting with watching the author’s video
[media = https: //www.youtube.com/watch? v = WS99-psOm7E]
So, to make a brazier from a car drive, we need:
- car drive;
- square grid 40 by 40 cm;
- three metal rods with a thread of 8 at the end;
- a metal square sheet measuring 250 by 250 mm and a thickness of 4-5 mm;
- welding machine.
First of all, we should weld a metal disk from the outside of the disk so that the hot corners do not fall through the large holes on the disk.
Let's move on to the next step. At this step, lightly bait nuts to weld them at the locations of the legs of the barbecue. The author claims that it is important to slightly bait, and not tighten the nuts completely to get removable legs without welding the rods to the structure.
The barbecue is almost ready. It remains to prepare the grid. To do this, put the grid on the disk, take a marker, circle the mode with the excess grinder.
Our brazier is ready. Corners need to be put in a disk. The holes that remain after welding the metal plate will contribute to blowing coal. Finally, the grill can be used without a grid, putting skewers with meat on it, or as a device for making barbecue. In this case, you can put a cut net in the rim of the disk and enjoy a delicious barbecue.
