Creation of a lamp based on a diode bridge, having the form of a "Pony Pegasus". It is quite simple to manufacture and has a fun look.
To create it you will need such materials:
- Pony toy (any hollow);
- LED garland;
- Bridge rectifier KBL608;
- Shrink or cambric;
- The wire;
- Glue stick for soldering (linoleum or carpet).
- tweezers;
- Soldering iron.
Bridge rectifier KBL608:
We solder the network wire, respectively, to the speaker legs, after putting on the cambric.
We prepare the garland by marking + and stripping and irradiating the ends of the wires.
We solder the wiring from the garland + and -, also wearing the cambric in advance.
Using a piece of the glue stick, melt it with a soldering iron and fix the cambric.
Since at the exit from the bridge 310 volts we calculate the number of LEDs:
310/3 = 103 i.e. 103 LEDs will be needed, so approximately 3-3.3 volts per LED.
Actually we make som assembly. We make a hole in the belly, in my case we precisely do it because the material is soft.
We check the performance. By pulling the wire, we begin to evenly distribute the LEDs.
Here we need tweezers.
Distributed primarily in the legs.
Finishing touch.
Comb.