IN home Does the library already run out of space for your favorite books, and do they slowly fill in all the free spaces in the rooms? This means one thing - you need to review and change some features of their storage. We are considering the option to construct do it yourself an unusual thing is a library chair where you can place your favorite volumes next to you and enjoy reading.
Sitting at your library is quite interesting and extraordinary. Shelves with a total length of 420 cm will be located around the perimeter of the chair. In terms of capacity, this is about 250 volumes, but if the books are pocket-sized, they will be about 400 pieces. The amount depends on the thickness of the books.
The height of the shelves is 23 cm, but this size can be changed, taking into account the parameters of your books. You can make a chair with your own hands at home, having spent several hours at work. It is necessary to transfer the drawings to the material (MDF boards and plywood), cut and perform the work according to the following instructions.
REQUIRED MATERIALS
- MDF plate (thickness-16 mm)
- plywood (thickness - 5 mm)
- foam rubber
- red velvet
- glue
- screws
OPERATING PROCEDURE
1. The side of the product must be glued to the side. To ensure that the parts are fixed perpendicularly, an additional plate is used. To maintain the correct position of the plates until the glue completely dries, you need to fix the outer corner with tape.
2. Next, the seat support is attached to the rear wall of the product with glue and screws. The support board is located in front.
3. The second side part is fixed - work on the inside of the chair is completed.
4. The marking of the place of fastening of shelves is made with the help of struts from MDF boards.
5. Drill holes for screws. All prepared parts are fastened with glue, and then with screws.
6. The location of the seat is noted.
7. Below the marking (paragraph 6), glue is applied and a seat plate is installed.
8. On the sides of the product there is a 100 ° angle between the seat and the back.
9. The armrests are tightly and butt-jointed by glue. Details are fixed with adhesive tape and fixed with tsulag until the glue completely dries.
10.Foam and velvet pillows can be made both to order and at home, and attached to the plywood with a furniture stapler.
The product is ready.
Enjoy your reading!