» Fixtures »We build a stand for heating cups

We build a stand for heating cups




Often we forget about the time when we are passionate about work, reading or a computer game. It would seem that they just made tea or made coffee, as it turns out that a cup with a cooled drink is in their hands.

Our cup warmer design helps keep the drink burning and warm in the winter cold. It is enough to put the dishes with the cooled drink on the surface and after a couple of minutes you can again enjoy hot tea or coffee.

We will need the following materials:
- a board about 27 mm thick;
- aluminum bar 12 mm thick;
- an aluminum plate 10 mm thick;
- 4 fixing screws with a diameter of 4 mm;
- beeswax;
- sandpaper.




Instruments:
-screwdriver;
-drill;
-drills (3.5mm, 12mm, 39mm);
- a jigsaw.

Step 1. We work with a tree

Draw a 10x10 cm square on the board. Then the diagonal lines from the vertices. Measure 2 cm from each corner and drill 12 mm holes with a 1 cm deep drill. In the center of the square, drill a 39 mm hole with a 1 cm deep drill. Saw the square with a jigsaw.






Step 2. We work with metal

Cut 4 elements from an aluminum bar 5 cm each. Drill a vertical hole in each 3.5 mm. Draw diagonal lines on an aluminum plate with an area of ​​10x10 cm. Measure 2 cm from each corner and drill holes each 3.5 mm deep.





Step 3. We work with sandpaper and wax

Polish with sandpaper aluminum and wooden elements. Wax the tree.



Step 4. Connect the elements

Insert the aluminum rods into the wood plate. Fasten the aluminum plate to the structure with screws.
The diameter of the screws is 4 mm, and the diameter of the holes is 3.5 mm, so in order to connect them you need to make some effort. But the design will hold tight.






Enjoy a hot drink! After the candle went out, the aluminum plate remains hot for about 15 minutes.
10
10
10

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose
1 a comment
Aleksandr-1
Very stylish little thing. I have a board, and a beech, very beautiful texture of this tree. You can get an aluminum bar, or replace it with nickel-plated tubes, it will also be simpler and more beautiful. There remains one problem - where to get an aluminum plate? And so everything can be done, it will turn out cool and original.

We advise you to read:

Hand it for the smartphone ...