An oriental-style aromalamp will help create a bewitching atmosphere in the room. Smooth flame of the “pill” candle and multi-colored glare on the wall will create a small holiday in the house.
Most of all, such an amazing homemade suitable for people who can afford the hour of solitude to behold the flame. The healing properties of fire were noticed many millennia ago. Like water, fire takes away fatigue and cleanses the soul of accumulated (albeit unconsciously) negativity per day.
To make such crafts it will take a couple of evenings, although you can make such a thing in a day.
For work you will need: any rigid wire of three and five mm thick, eight decorative rings of thin wire (ring diameter - 1-1.2 cm), thin copper wire, 40 plastic multi-colored round beads, eight elongated beads (possible in the form droplets), bronze paint, several bags of multi-colored small beads (preferably oblong), a soldering iron, a piece of metal and special scissors.
The aroma lamp will be in the form of a mini floor lamp 25 cm high.
Where do we start?
1. From a thick wire, make a circle with a diameter of 9 mm. (Wire a suitable cup around the wire and solder its ends).
2. From a medium-thick wire, cut five pieces 7 cm long.
3. Break the circle (lamp base) into 5 identical sectors. You can draw a diagram on a piece of paper by writing a pentagon into a circle. Or simply solder each of the 5 pieces of wire to the circle at a distance of 5 cm from each other. Pre-bend the pieces of wire in the middle a little.
4. Soldering the pieces, carefully bring them to one point and solder again, but to the floor lamp axis - a thick wire 11 cm long.
5. Use a metal plate as a candle bowl. To do this, cut a circle with a diameter of 5.5 cm from it. Then cut a strip 1 cm high. Bend it into a circle and solder to a mug. The diameter of this side for the candle should be 4 cm. Thus, on the base circle there will remain 0.5-0.6 mm of indentation, on which the upper part of the mini-floor lamp will be held.
6.Getting to the manufacture of "caps". Make 4 squares of medium-thick wire with sides of 10, 9, 7 and 6 cm.
7. Cut 4 pieces of 8 cm from the same wire.
8. Take one piece of the short wire and solder it in the corner of the lower, widest square, at an angle. On top of the side bar, put on a 9 cm square and solder it the same way, at a distance of 2 cm from the first. The side planks will bend themselves in the right direction. The third square is 4 cm from the second, and the fourth is 2 cm from the third. You will get 4 squares connected in the corners by four bars.
9. From a medium-thick wire, make a circle with a diameter of 4.5 mm. Cut 4 pieces of wire 3 cm. Place your future lampshade on the table with the small base (the smallest square) down. Solder a piece of wire in the middle of each of the four sides. Solder a circle to its free ends. He will keep the lampshade on the side of the bowl. Coat both parts of the lamp with bronze paint.
10. Take a thin copper wire and, connecting it with the first two wide squares, string large round beads. Walk all the way around. These same beads adorn the upper edge of the lamp. Wrap the middle with the same wire and, tangling it, string small pebbles on it, connecting the second and third squares with this copper thread, i.e. two middle ones. On the other hand, you can weave any decoration for your lampshade using this base. On the edges of the largest square, hang two bead drops on thin ringlets.
11. Light a candle and connect the two parts of the aroma lamp.