Step 1:
The author printed a sketch of a future rocket on a printer, cut out paper details. I pasted it on birch plywood 11 mm thick. After which he cut them out, for this he used a band saw.
Step 2:
The next task was to drill a hole for the bulb holder. He cut a hole with a screwdriver with a wood crown fixed on it. In two parts in the form of a gear. After that, he cleaned all the parts from burrs with sandpaper.
Step 3:
It remains only to put everything together. The author made the assembly without glue, since the parts fit perfectly together and without him, he only tapped a little with a hammer. We screw a lamp into the cartridge; it was bought at a hardware store.
Rocket ready
So the whole stages of creating a rocket ended. We can take a look at the result.
